Tianhui Machine Co.,Ltd
Figure 1 Selection of the end slot cutter location
Figure 2 End position of the tool during layered cutting
Figure 3 isometric cutting method
As shown in Figure 1, the end slot cutter is used to measure the P1 point. It is convenient to measure the P2 point. Therefore, it is better to select P1 as the tool position than P2, but if the tool position is adjusted and compensated, it is trial cut. The method determines, and the machining accuracy of the ring small circle is higher than the large circle precision, then P2 is selected as the tool position is better than P1.
3 End position of the tool during layer cutting
When the machining allowance of a certain outer surface is required to be multi-layered and cut, it is necessary to pay attention to prevent the sudden increase of the amount of back-feeding from the second knife. As shown in Fig. 2, it is reasonable to arrange the outer circle of the tool with a 90° lead angle. The reasonable arrangement should be that the cutting end of each knife is advanced by a small distance e (e=0.05). If e = 0, that is, each knife terminates at the same axial position, the main cutting edge of the turning tool may be subjected to an instantaneous heavy load impact. For example, the end position of the layered cutting to make the layer retreat arrangement is beneficial to extend the service life of the roughing tool.
Previous page next page
October 14, 2024
September 27, 2024
この仕入先にメール
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
