Tianhui Machine Co.,Ltd
The commonly used tool path for machining parts on CNC lathes:
(1) analysis of the car's arc path
When the actual car arc, it needs multi-knife processing, first remove most of the excess, and finally the car needs the arc. The following describes the processing route commonly used for car arcs.
Figure 1 shows the course of the arc of a car.
figure 1
Figure 2 (a) is a concentric circular arc path for the car arc.
figure 2
Figure 3 shows the car cone cutting course of the arc
That is, a car first cone, and then car arc.
image 3
(2) analysis of the path of the car cone
Figure 4
(3) Analysis of axial feed distance when threading
Figure 5
(4) analysis of cutting path
In the case of a rectangular groove with low turning accuracy and narrow width, a slot cutter with a blade width equal to the slot width can be used to feed the car at a time using the straight-in method. Grooves with higher accuracy are generally used as secondary feeds, ie, when feeding the trough for the first time, the remaining amount of fine cars is left on both sides of the trough, and the second pass is trimmed with a constant width knife.
The wide groove of the car can be cut by multiple straight-through methods, leaving a fine machining allowance in the groove wall and the bottom surface, and the last knife to the size. As shown in Figure 6.
Figure 6
October 14, 2024
September 27, 2024
この仕入先にメール
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
