Automatic lathe machining tools and turning tools
April 29, 2023
Do not put the automatic lathe processing tools and turning tools on the bed surface to avoid knocking the guide rails. If you need to put it, cover the bed cover on the bed and put the tool and the knife on the bed cover.
a When sanding the workpiece, cover it with a bed cover or paper on the bed under the workpiece; after sanding, carefully clean the surface of the bed.
b When the cast iron workpiece is in the car, install the guard cover on the stern plate, and at the same time wipe off the lubricating oil on the surface of the bed that the chip can splash.
c When not in use, the lathe must be cleaned and maintained to prevent chips, sand or impurities from entering the sliding surface of the lathe rail, causing the rail to “bite” or aggravate its wear.
d Before using the cooling lubricant, the garbage in the lathe rail and the cooling lubricant pan must be removed; after use, the cooling lubricant on the rail should be wiped dry and mechanically lubricated.
